The new and improved Ultra Nator™ control and alarm system controls two alternating 120V 1 HP or 15 Amp single phase pumps in duplex pump applications.
The plug and play design feature a factory-installed 10' power cord, floats and pump receptacles (no field wiring required to quickly connect two sump pumps).
The new battery back-up alarm system maintains the alarm function if primary power is lost; you can quickly test the battery condition with the battery test function. The new pump failure indicator alerts you to potential pump problems, such as non-operating pumps, problems with outflow plumbing, or if the water inflow is greater than pumping capacity. The reference chart on the panel front helps the operator diagnose problems quickly.
In normal operation, the pump will alternate based on the pump switch level. If an alarm condition occurs (top float activates), the alarm light and horn turn on. The pump in use will turn off and the other pump will turn on. Pumping will continue until the pump switch deactivates (bottom float).
Features
NEMA 1 Rated for Indoor Use
120AC Voltage - Primary 120V; Secondary 9 VDC
If Primary Power Fails, the Alarm System Continues to Work Due to Battery Back-Up Feature (battery not included)
Pump Failure Indicator to Alert of Potential Pump Problems
Red LED High Water Indicator
Amber LED Horn Disables Indicator
Green LED Pump Run Indicators (pump 1, pump 2)
Green LED Power on Indicator
Sleek Touch Pad Button Switches
Alarm Test
Horn Silence
Manual Pump Run
Test/Reset
Battery Test
Angled Receptacles to Accept Standard or Right-Angled Pump Plugs
Auxiliary Contacts (normally open and normally closed) Included on all Models to Interface with Remote Alarms, Auto Dialers, and Home Security Systems
Alternating Pump Action Equalizes Pump Wear
Factory-Installed 10 ft. Power Cord
Factory-Installed Pump Activation and Alarm Activation Switches for Easy Installation (various switch configurations available)
