The Automated Flow Systems AFSCPS120/240 Simplex Dual Voltage control panel is designed to control one 120/208/240V single phase pump in water and sewage installations.
Features
Electromechanical Control
Demand Dosing
120-240 Volts Single Phase
Two-Wire Pumps up to 20 FLa
Simplified Wiring
Lockable NEMA 4X Enclosure
Power Relay Silences Contactor Hammer to Allow for Additional Mounting Options
Applications
Residential and Light Commercial Simplex Wastewater Pumping Applications
Reservoir Pump Up and Alarm Applications
General Simplex Pump Control Applications
Float Arrangement (from top down)
High Level Alarm - activates audible and visual alarm when pump is not operational or activated. Audible alarm can be deactivated by pressing High Alarm Push to Silence button on front of panel
Pump ON - provides closure signal to power relay to activate pump/motor
Pump OFF - releases pump holding circuit deactivating power relay and pump/motor
Redundant OFF - insures pump will not run under low level conditions and also provides audible and visual alarm to indicate tank leak or siphoning of tank contents
Multi Voltage - Built to operate 120, 208, or 240 volt single phase pumps/motors. Controls two-wire pumps up to 20 full load amps.
Simplified Wiring - Equipped with separate pump and alarm circuit breakers to accommodate installation with one or two circuits. Allows up to four floats with two terminals per float, eliminating the need for bundling common wires in the panel or splice box. Panel ships with a terminal link installed to bypass the redundant off float when not required.
Power Relay - Pump power is switched with a nearly silent power relay. The power relay is rated for 30 amps and 100,000 or more cycles
Have a question about control panels? You can live chat with us at www.rcworst.com, call 855.329.4519, or email Customer.Service@RCWorst.com to reach an industry expert.
