Zoeller Charger Control Assembly Description
The 10 AMP 12V Battery Charger is used for maintaining the battery in a ready state and recharging the battery after use when AC power is restored. Time for
recharge depends upon the amount of power consumed by the pumping cycle
during the AC power interruption. The pump may go back to the ready run
position in a very short period of time. A completely drained battery may
require up to 24 hours for full recharge. If after 24 hours of charging the
battery has not reached 6 volts, the alarm will sound and not reset until
the battery is brought up to a voltage of 6.5-7.0 volts. Purchase this Zoeller battery charger today.
Zoeller Sump Pump Battery Charger Control Assembly Features and Benefits
-
LED Status Indicators
-
Automatic Battery Recharging
-
Microprocessor Controlled
-
Each Unit Individually Tested
-
3.5 Amp AC Input
-
DC Output
-
Because This Unit Converts AC to DC, This Pump will Operate for an
Extended Time as a Backup Unit in Case of Primary Pump Failure
Zoeller Charger Control Assembly Specifications
VOLTAGE: 12V AMPS: 10
WARNING:
Cancer and Reproductive Harm - www.P65Warnings.ca.gov