SJE-Rhombus Model IFS In-Site Single Phase 120/208/240V Simplex Control Panel

IFS In-Site Single Phase Simplex Control Panel Description

Demand Dose or Timed Dose, Float or C-Level™ Sensor Controlled System for Pump Control, System Monitoring, Event Logging and Reporting

The IFS In-Site® Simplex control panel utilizes an innovative circuit board design to control one 129/208/240V single phase pump in water and sewage applications. IFS panels feature an easy-to-use touch pad on inner door for programming and system monitoring. Quick retrieval of all system events can be done by downloading panel information onto a USB flash drive. The panel configuration can be easily converted in the field to either a timed dose or demand dose. Available with the EZconnex® float system.

Monitor system events including pump run times, pump cycles, alarm conditions, power outages, service calls and more! Quick convenient reports make diagnosing system conditions easy! Plug the flash drive into the USB port located on the inner door of the IFS In-Site® panel to download system events which occurred. No computer is needed at the site! Use the flash drive (included with the panel) with any computer to download system information and reports. The pre-loaded software on the flash drive formulates system data for you, creating reports quickly in an easy-to-read format so system conditions can be easily identified and corrected. In addition to monitoring system events, the IFS In-Site® panel logs any service calls and changes made to system settings, which helps protect service providers.

The panel can utilize the C-Level™ sensor for continuous level monitoring. It senses the level in the tank and sends a signal to the panel. Pump activation levels can be adjusted by using the panel touch pad. C-Level™ CL40 sensor operating range is 3-39.9 inches (7.6-101.3 cm). C-Level™ CL100 operating range is 3-99.5 inches (7.6-252.7 cm).

SJE-Rhombus Model IFS Single Phase Simplex Panel Features

Touch Pad Features:

Level Status Indicators
Hand/Off/Automatic (HOA) Buttons
Pump Run Indicators
LED Display Shows System Information (see below)
Next Push Button
Up and Set Push Buttons

LED Display Features:

Mode
Pump Elapsed Time (hh:mm)
Events (cycles)
Alarm Counter
Float Error Counter
Timed Dose Override Counter (TD only)
On/Off Times (TD only)
Sequence On/Off Times (TD only)
Level in Inches or Centimeters (C-Level™ sensor only)

Panel Features:

NEMA 4X Enclosure
Red Alarm Beacon Provides 360° Visual Check of Alarm Condition
Exterior Alarm Test/Normal/Silence Switch Allows Horn and Light to be Tested and Horn to be Silenced in an Alarm Condition; Alarm Automatically Resets Once Alarm Condition is Cleared
Alarm Horn Provide Audio Warning of Alarm Condition
Circuit Breaker (optional) Provides Pump Disconnect and Branch Circuit Protection
Power Relay Controls Pump by Switching Electrical Lines; Definite Purpose Contactor Used when Pump FLA is Above 15
Float Connection Terminal Block
Incoming Control/Alarm Terminal Block
Control Power Indicator/Fuse
Alarm Power Indicator/Fuse
Ground Lug
Incoming Pump Power Connections
RF Filter
Power Supply
USB Port
Manuals Report Switch
Five-Year Limited Warranty on Panel
One-Year Limited Warranty on C-Level™ Sensor
UL/cUL Listed

SJE-Rhombus Model IFS Single Phase Simplex Panel Components

TOUCH PAD FEATURES:

Level Status Indicators Illuminate when Floats or Set Points are Activated; Alarm will Activate if a Float Operates out of Sequence.
HOA (Hand-Off-Automatic) Buttons with Indication Control Pump Mode; Hand Mode Defaults to Automatic when Stop Level or Redundant Off Level is Reached.
Pump Run Indicator Illuminates when Pump is called to Run.
LED Display Shows System Information Including: Level in Inches or Centimeters (C-Level™ sensor only), Mode, Pump Elapsed Time (hh:mm), Events (cycles), Alarm Counter, Float Error Count, Timed Dose Override Counter (timed dose only), Pump ON/OFF Times (timed dose only), and Sequence ON/OFF Times (timed dose only).
NEXT Push Button Toggles Display.
UP and SET Push Buttons used to Set Pump ON/OFF Times (timed dose only), date and hour, activation levels (C-Level™ only).

PANEL COMPONENTS:

Enclosure Base Measures 14 X 12 X 6 inches (35.56 X 30.48 X 15.24 cm). NEMA 4X (ultraviolet stabilized thermoplastic with removable mounting feetfor outdoor or indoor use).
Red LED Beacon Provides 360° Visual Check of Alarm Condition.
Exterior Alarm Test/Normal/Silence Switch Allows Horn and Light to be Tested and Horn to be Silenced in an Alarm Condition. Alarm Automatically Resets Once Alarm Condition is Cleared.
Alarm Horn Provides Audio Warning of Alarm Condition (83 to 85 decibel rating) (NOT SHOWN).
Circuit Breaker (optional) Provides Pump Disconnect and Branch Circuit Protection.
Power Relay Controls Pump by Switching Electrical Lines; Definite Purpose Contactor Used when Pump Full Load Amps are Above 15.
Float Connection Terminal Block
Incoming Control/Alarm Power & Pump Terminal Block
Control Power Indicator/Fuse Indicator Light Illuminates if Control Power is Present in Panel. Alarm will Activate if Control Fuse is Blown.
Alarm Power Indicator/Fuse Indicator Light Illuminates if Alarm Power is Present in Panel.
Ground Lug
Incoming Pump Power Connections
RF Filter
Power Supply
Control Fuse
Alarm Fuse
USB Port for Flash Drive to Download Time-Stamped System Events
Manual Report Switch Date and Time Stamps Service Calls

NOTE: Options, Voltage and Amp Range Selected May Change Enclosure Size and Component Layout

NOTE: Schematic/Wiring Diagram and Pump Specification Label are Located Inside the Panel on Enclosure Cover.

WARNING Cancer and Reproductive Harm - www.P65Warnings.ca.gov WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov

SJE-Rhombus Model IFS - Single Phase Simplex Pump Control

SJE-Rhombus Model IFS - Single Phase Simplex Control Panel Catalog Page

SJE-Rhombus Model IFS - Single Phase Simplex Control Panel Installation Instructions

SJE-Rhombus Model IFS - C-level Sensor Installation Instructions

SJE-Rhombus Model IFS - Single Phase Simplex Control Panel Level Monitoring Brochure

SJE Rhombus Limited Warranty Policy

Five-Year Limited Warranty Policy We Stand Behind Our Products!

Effective for products manufactured after January 1, 2014

SJE-Rhombus warrants to the original consumer that this product shall be free of manufacturing defects for five years* after the date of consumer purchase. During that time period and subject to the conditions set forth below, SJE-Rhombus will repair or replace, for the original consumer, any component which proves to be defective due to defective materials or workmanship of SJE-Rhombus.

THE FIVE-YEAR LIMITED WARRANTY DOES NOT APPLY TO THE MOTOR START KIT COMPONENTS. SJE-RHOMBUS WILL WARRANTY MOTOR START KIT COMPONENTS, SUPPLIED BY SJE-RHOMBUS FOR ONE YEAR. SJE-RHOMBUS MAKES NO WARRANTIES OF ANY TYPE WITH RESPECT TO MOTOR START KITS SUPPLIED BY A CUSTOMER.

ELECTRICAL WIRING AND SERVICING OF THIS PRODUCT MUST BE PERFORMED BY A LICENSED ELECTRICIAN.

This warranty does not apply to: (a) damage due to lightning or conditions beyond the control of SJE-Rhombus; (b) defects or malfunctions resulting from units not installed, operated, or maintained in accordance with instructions provided, applicable local codes, ordinances, or accepted trade practices; (c) failures resulting from abuse, misuse, accident, or negligence; or (d) units repaired and/or modified without prior authorization from SJE-Rhombus.

Some states do not allow limitations on how long an implied warranty lasts, so the above limitation may not apply to you. Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion may not apply to you. This warranty gives you specific legal rights, and you may also have other rights which vary from state to state.

TO OBTAIN WARRANTY SERVICE: The consumer shall assume all responsibility and expense for removal, reinstallation, and freight. Any item to be repaired or replaced under this warranty must be returned to SJE-Rhombus, or such place as designated by SJE-Rhombus. Contact customer service at 1-888-DIAL-SJE (1-888-342-5753) for a Return Materials Authorization number (RMA) on any product being returned for a warranty claim.

ANY IMPLIED WARRANTIES OF MERCHANTABILITY OR FITNESS ARE LIMITED TO THE DURATION OF THIS WRITTEN WARRANTY. SJE-RHOMBUS SHALL NOT, IN ANY MATTER, BE LIABLE FOR ANY INCIDENTAL OR CONSEQUENTIAL DAMAGES AS A RESULT OF A BREACH OF THIS WRITTEN WARRANTY OR ANY IMPLIED WARRANTY.

*Build-A-Panel™ Plus Control Panels and Engineered Custom panels carry a two-year limited warranty (or as quoted). The pressure transducer included with VARIOspeed® products carries a one-year limited warranty.