Zoeller Model 264 Sewage Pump Description
Our Model N264 Sewage Pump is designed to remove raw sewage or effluent in residential sewage or septic system applications. The professional-grade, 4/10 HP Model 264 is known for its dependability. The N264 is a nonautomatic pump requiring a piggyback float switch or control panel for operation. Either option allows you to set the on and off point of the pump in the field. This is ideal in an application with a deep sump pit or pump tank.
The Model 264’s motor housing and pump housing are each constructed of cast iron. The pump’s identification tag handle, and hardware are made of non-corrodible stainless steel. This attention to detail ensures that the Model 264 is able to withstand the demands of residential sewage ejector applications.
Every pump is submerged in water and tested to its published performance curve, ensuring it meets your expectations and delivers peace of mind right-out-of-the-box.
Zoeller Model 264 Sewage Pump Features and Benefits
- Oil Filled Motor Optimizes Heat Dissipation which Prevents the Pump from Overheating During Extended-Use Occurrences
- Nonautomatic Pump (Piggyback Variable Level Float Switch Available Separately
- Corrosion Resistant Engineered Plastic Vortex Impeller to Allow Free Passage of 2" Spherical Solids Which Prevents Clogging and Increases Reliability
- Powder-Coated Epoxy Finish Provides Corrosion-Resistance and Extends Pump Life in Harsh Environments
- Stainless Steel Screws and Handle to Prevent Rust and Corrosion
- 100% Factory Tested: Our Factory-Tested Pumps Ensure Reliable Performance in Challenging Applications with Fewer Concerns about Mechanical Failures
- Comes with a 3-Year Limited Warranty Giving You Protection Over Your Investment and the Peace of Mind you Expect in a Quality Product
Zoeller 264-0010 Sewage Pump Specifications
- VOLTAGE: 1ø, 115V, 60Hz
- HORSEPOWER: 0.4 HP
- AMP DRAW (full load): 9.4
- MOTOR TYPE: Permanent Split Capacitor (PSC)
- RPM: 1725 RPM
- MAXIMUM HEAD: 18'
- MAXIMUM CAPACITY: 90 GPM
- SWITCH TYPE: Manual
- DISCHARGE PIPE SIZE: 2" NPT
- MAXIMUM SOLIDS HANDLING: 2" Spherical Solid
- IMPELLER TYPE: Engineered Plastic, Non-Clogging Vortex
- CORD LENGTH: 25' Type UL Listed, 3-Wire Cord and Plug
- BODY CONSTRUCTION: Cast Iron
- MAXIMUM OPERATING TEMPERATURE: 130°F (54C)
Zoeller Model 264 Sewage Pump Performance Curve
WARNING:
Cancer and Reproductive Harm - www.P65Warnings.ca.gov
Zoeller Limited Warranty
Manufacturer warrants, to the purchaser and subsequent owner during the warranty
period, every new product to be free from defects in material and workmanship
under normal use and service, when properly used and maintained, for a period of
three years from the date of purchase. Proof of purchase is required. Parts that fail
within the warranty period, that inspections determine to be defective in material
or workmanship, will be repaired, replaced or remanufactured at Manufacturer's
option, provided however, that by so doing we will not be obligated to replace an
entire assembly, the entire mechanism or the complete unit. No allowance will be
made for shipping charges, damages, labor or other charges that may occur due to
product failure, repair or replacement.
This warranty does not apply to and there shall be no warranty for any material or
product that has been disassembled without prior approval of Manufacturer, subjected
to misuse, misapplication, neglect, alteration, accident or act of nature; that has not
been installed, operated or maintained in accordance with Manufacturer's installation
instructions; that has been exposed to outside substances including but not limited to
the following: sand, gravel, cement, mud, tar, hydrocarbons, hydrocarbon derivatives
(oil, gasoline, solvents, etc.), or other abrasive or corrosive substances, wash towels
or feminine sanitary products, etc. in all pumping applications. The warranty set out in the paragraph above is in lieu of all other warranties expressed or implied; and
we do not authorize any representative or other person to assume for us any other
liability in connection with our products.
Contact Manufacturer at, 3649 Cane Run Road, Louisville, Kentucky 40211, Attention:
Customer Service Department to obtain any needed repair or replacement of part(s)
or additional information pertaining to our warranty.
MANUFACTURER EXPRESSLY DISCLAIMS LIABILITY FOR SPECIAL,
CONSEQUENTIAL OR INCIDENTAL DAMAGES OR BREACH OF EXPRESSED
OR IMPLIED WARRANTY; AND ANY IMPLIED WARRANTY OF FITNESS FOR A
PARTICULAR PURPOSE AND OF MERCHANTABILITY SHALL BE LIMITED TO
THE DURATION OF THE EXPRESSED WARRANTY.
Some states do not allow limitations on the duration of an implied warranty, so the
above limitation may not apply to you. Some states do not allow the exclusion or
limitation of incidental or consequential damages, so the above limitation or exclusion
may not apply to you.
This warranty gives you specific legal rights and you may also have other rights which vary from state to state.