Power-Flo PFSE Series Sewage Pump Description
Submersible sewage pumps designed for typical raw sewage applications.
Power-Flo PFSE Series Sewage Pump Application
Designed for Handling Typical Septic Tank / Effluent Applications.
Power-Flo PFSE Series Sewage Pump Features
- DISCHARGE: 3” NPT, Female, Vertical, Bolt-On Flange
- LIQUID TEMPERATURE: 104°F Continuous
- MOTOR HOUSING/VOLUTE: Cast Iron, Class 30
- IMPELLER: 2 Vane, Open Type , Cast Iron, Class 30
- SHAFT & HARDWARE : Stainless Steel
- O-RINGS: Buna-N
- SEAL: Inboard, Single Mechanical, 1 inch, Oil Filled Reservoir, Carbon/Ceramic/Buna-N with Secondary Exclusion Seal
- UPPER BEARING: Single Row, Ball, Oil lubricated
- LOWER BEARING: Single Row, Ball, Oil Lubricated
- POWER CORD: 1-1/2 & 2HP, 3HP - 25ft., SOW Cord, Pressure Grommet for Sealing and Strain Relief. 1-1/2, 2HP, 1PH & 3PH - 25 Ft. SOW, Cord. Epoxy Sealed Housing with Secondary Pressure Grommet for Sealing and Strain Relief.
- MOTOR: Class B Insulation, Oil Filled, Squirrel Cage Induction
- SINGLE PHASE: Permanent Split Capacitor (PSC), Includes Overload Protection in Motor
- THREE PHASE: 230/460 is Dual-Voltage Motor. Requires Overload Protection to be Included in Control Panel
- WARRANTY: 1 Year
Power-Flo PFSE1544 Specifications
- VOLTAGE: 3ø, 460V, 60Hz
- HORSEPOWER: 1.5 HP
- AMP DRAW (full load): 5.8
- MOTOR TYPE: Permanent Split Capacitor (PSC)
- RPM: 1750
- MAXIMUM HEAD: 40'
- MAXIMUM CAPACITY: 370 GPM
- SWITCH TYPE: Manual
- DISCHARGE PIPE SIZE: 3” NPT, Female, Vertical, Bolt-On Flange
- MAXIMUM SOLIDS HANDLING SIZE: 2.5"
- IMPELLER TYPE: Cast Iron, Class 30, 2 Vane, Open Type
- IMPELLER DIAMETER: 6.25"
- CORD LENGTH: 25', Type: SOW
- CORD SIZE: 10/4 Cord with Plug
- BODY CONSTRUCTION: Cast Iron, Class 30
- MAXIMUM LIQUID TEMPERATURE: 104°F Continuous
Power-Flo PFSE Series Sewage Pump Performance Curve
WARNING:
Cancer and Reproductive Harm - www.P65Warnings.ca.gov