Littelfuse PC-102CICI-LT Seal Leak / Temp Detector Description
The PC-102CICI-LT has a Seal-leak and over-temperature detector that uses one input to sense seal failures and the temperature input to detect motor overheating. Configurable to suit various probes. Seal input logic direct or inverted, plus over-temperature trip reset automatic or manual, is DIP switch selectable.
Both units have two form-C isolated output relays and two LEDs,
which illuminate when each associated output relay is energized.
The sensitivity adjustment (4.7k-100kOhms) allows you to
define the input impedance at which the output relays will
change state. The sensitivity for the over-temperature detector
can be set to 4k Ohms with use of the DIP switches.
This Unit May Not Be Compatible with Flygt Pumps
Littelfuse PC-102CICI-LT Seal Leak / Temp Detector Typical Applications
- Compressors
- HVAC
- Heat Pumps
- Well Pumps
- Sump Pumps
- Small Conveyor Motors
- Oil Rigs
Littelfuse PC-102CICI-LT Seal Leak / Temp Detector Product Features
- Dual Inputs
- Input Logic may be Selected to be Direct or Inverted
- Two Isolated Form-C Output Relays
- Two Red LEDs
Littelfuse PC-102CICI-LT Dual Seal Leak Detector Product Specifications
Line Voltage . . . . . . . . . . . . 120 VAC Nominal
Frequency . . . . . . . . . . . . 50/60Hz
Probe Sense Voltage . . . . . . . . . 5vdc pulsed
Sensitivity . . . . . . . . . . . . . .4.7k-100kΩ
Sensitivity (for temp) . . . . . . . . . . . . Selectable 4kΩ with DIP switches
Input Logic . . . . . . . . . . . . . . . . . . . . . Direct or inverted<
Debounce Time Delay . . . . . . . . . . . . . . . . . . . . . 0.5 or 2 seconds
Relay Output Rating
- 2 Form C Isolated. . . . . . . . . . . . . . . . . . .180VA @ 120VAC, C150 Pilot Duty
- . . . . . . . . . . . . . . . . . . . . . 5A @ 240VAC General Purpose
Temperature Range . . . . . . . . . . . . . . . . . . . . . -20° to 55°C (-4° to 131°F)
Maximum Input Power . . . . . . . . . . . . . . . . . . . . . 2 W
Depluggable Connector . . . . . . . . . . . . . Phoenix Contact-Series MSTB plugs
Output Relay Status Indicators . . . . . . . . . . . . . . . . . . . . . . . . LEDs
Terminal Torque . . . . . . . . . . . . . . . . . . . . . . . .4.5 in.-lbs
Wide Range . . . . . . . . . . . . . . . . . . . . . . . .12-20 AWG
Electrostatic Discharge (ESD) . . . . . . . . . IEC 61000-4-2, Level 3, 6kV contact, 8kV air
Radio Frequency Immunity (RFI) . . . . . . . . . IEC 61000-4-3, Level 3, 10V/m
Fast Transients . . . . . . . . . IEC 61000-4-4, Level 3, 4kV input power 2kV inputs/outputs
Safety Mark
- UL . . . . . . . . . . . . . . . . . . . . . . . UL508 (File #E68520)
Weight . . . . . . . . . . . . . . . . . . . . . . . . 14.4 oz.
Mounting Method
. . . . . . . . . . . 35mm DIN rail or Surface Mount (#6 or #8 screws)
WARNING:
Cancer and Reproductive Harm - www.P65Warnings.ca.gov
SymCom Warranty
SymCom Limited Warranty
Terms and Conditions of Sale
Effective January 1, 2009 General Remarks: These Terms and Conditions of Sale apply to all sales and deliveries effected by SymCom. Any terms or conditions on the part of the purchaser that are contrary to these shall not be binding on SymCom, even if they form the basis of the order. Prices: Subject to change without notice. Minimum order is one hundred-fifty dollars ($150.00), excluding shipping charges. Terms: Net 30 days from ship date with approved credit. New customers requesting trade credit must submit a credit application prior, and receive approval prior to an order being placed in production. Handling Fee: A $5.00 handling fee will be assessed on each order. Delivery: Buyer's delivery schedule will be met to the best of SymCom's ability. SymCom reserves the right to make partial shipments on any order. SymCom is not responsible for shipping errors on behalf of the carrier. Freight: All sales are F.O.B., SymCom, Inc., Rapid City, SD. Shipments will be made by the transportation method selected by the Buyer whenever practical. Warranty: SymCom warrants its standard products against defects in material or workmanship for a period of five (5) years from the date of manufacture. All third-party products are warranted by their manufacturer and are handled as a pass-through warranty by SymCom. All custom and private labeled products are warranted for eighteen (18) months unless otherwise stated in writing. The liability of SymCom is limited, at its option, to replace, repair, or credit at the purchase price, for any devices which are returned during the warranty period and which prove to be defective. This warranty constitutes SymCom's sole liability here under and is in lieu of any other warranty expressed, implied or statutory, written or oral, including without limitation, any implied warranties of merchantability or fitness for a particular purpose and supersedes any representations made by any person which are inconsistent with or expand the terms set forth in this document. No person is authorized to modify this warranty in any way whatsoever. Limits of Liability: IN NO EVENT, REGARDLESS OF CAUSE, SHALL SYMCOM BE LIABLE FOR (1) PENALTIES OR PENALTY CAUSES OF ANY DESCRIPTION OR (2) FOR CERTIFICATION NOT OTHERWISE SPECIFICALLY PROVIDED HEREIN AND/OR INDEMNIFICATION OF BUYER TO OTHERS FOR COSTS, DAMAGES OR EXPENSES, EACH ARISING OUT OF OR RELATED TO THE PRODUCT OR SERVICES OF ANY ORDER OR (3) FOR ANY DAMAGES, WHETHER GENERAL, SPECIAL, OR FOR NEGLIGENCE, AND EXPRESSLY EXCLUDES DAMAGES RESULTING FROM LOSS OF PROFITS, USE OF PRODUCTS, ANY INCIDENTAL, OR INDIRECT CONSEQUENTIAL DAMAGES EVEN IF ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SYMCOM'S OBLIGATION TO REPAIR, REPLACE OR CREDIT THE PURCHASE PRICE SHALL BE THE LIMIT OF ITS LIABILITY UNDER THIS WARRANTY. Returns: All returns must be authorized by SymCom and must have a Return Material Authorization (RMA) number. Issuance of a RMA number does not acknowledge goods as defective or under warranty by the seller. Unauthorized returns will be refused. Authorized returns must be shipped freight prepaid and are subject to inspection and/or testing prior to disposition. Product built to Buyer's specifications cannot be returned for credit or exchanged under any circumstances. For SymCom’s complete RMA terms, please visit our website. Cancellation of Custom or Non-Preferred Products: Buyer may cancel an order upon written notice to SymCom's customer service department and upon payment of cancellation charges, which shall include all costs, both direct and indirect, incurred and/or committed. SymCom agrees to divert completed work and work in progress from a cancelled order to other orders whenever possible. Cancellation of Preferred Products: Full refund if returned within 30 days of purchase. Unit must be in original packaging and in new condition. An RMA must be issued for any return.