Flint & Walling CPH05 Model CPH Convertible Jet Pump 0.5 HP 115V/230V 1PH

• High Tensile Gray Iron Pump Bodies: Large Water Cavities Provide Fast, Easy Priming.
• Buna-N Square Cut Ring: Reusable - Provides A Positive Seal Between the Pump Case and Motor Bracket.
• Molded Diffusers: Corrosion and Abrasion Resistant, Provide Precision Alignment with the Impeller for Maximum Performance.
• Impellers: Precision Balanced, these Impellers are Ultra-Smooth for High Efficiency.
• Pipe Plugs and Priming Plugs: Coated With A Non-Hardening, Non-Toxic, Non-Corrosive Material which Allows for Easy Removal Even After Pump has Been in Service for Years.
• Standard Shaft Seal: Silicone Carbide Face is Self-Adjusting Throughout the Seal Life. One Size Fits All Models.
• CPJ Models: Feature NEMA J Motors. All Motors are Dual Voltage, Capacitor Start with Automatic Thermal Overload Protection.
• Automatic Overload: Senses Both Start and Run Winding Heat to Ensure Complete Winding Protection.

• DISCHARGE SIZE: 0.75"
• INLET SIZE: 1.25"
• IMPELLER MATERIAL: Thermoplastic
• BODY CONSTRUCTION: Cast Iron
• HORSEPOWER: 0.5 HP
• MOTOR TYPE: Uni-Frame Motor
• VOLTAGE: 1ø, 115V/230V, 60Hz
• RPM: 3450

Standard Warranty Terms

See product literature for specific warranty period.

Subject to the conditions hereinafter set forth, the manufacturer will repair or replace to the original consumer, any portion of the product which proves defective due to defective materials or workmanship. This warranty does not cover replacement parts for failure due to normal wear and tear. To obtain warranty service, contact the dealer from whom the product was purchased. The manufacturer retains the sole right and option to determine whether to repair or replace defective equipment, parts or components. Damage due to conditions beyond the control of the manufacturer is not covered by this warranty.

THIS WARRANTY WILL NOT APPLY:

1. To defects or malfunctions resulting from failure to properly install, operate or maintain the unit in accordance with printed instructions provided;
2. to failures resulting from abuse, accident or negligence or use of inappropriate chemicals or additives in the water;
3. to normal maintenance services and the parts used in connection with such service;
4. to units which are not installed in accordance with normal applicable local codes, ordinances and good trade practices; and
5. if the unit is used for purposes other than for what it was designed and manufactured.

RETURN OF WARRANTED COMPONENTS:

Any item to be repaired or replaced under this warranty must be returned to the manufacturer at Kendallville, Indiana or such other place as the manufacturer may designate, freight prepaid.

THE WARRANTY PROVIDED HEREIN IS IN LIEU OF ALL OTHER EXPRESS WARRANTIES, AND MAY NOT BE EXTENDED OR MODIFIED BY ANYONE. ANY IMPLIED WARRANTIES SHALL BE LIMITED TO THE PERIOD OF THE LIMITED WARRANTY AND THEREAFTER ALL SUCH IMPLIED WARRANTIES ARE DISCLAIMED AND EXCLUDED. THE MANUFACTURER SHALL NOT, UNDER ANY CIRCUMSTANCES, BE LIABLE FOR INCIDENTAL, CONSEQUENTIAL OR SPECIAL DAMAGES, SUCH AS, BUT NOT LIMITED TO DAMAGE TO, OR LOSS OF, OTHER PROPERTY OR EQUIPMENT, LOSS OF PROFITS, INCONVENIENCE, OR OTHER INCIDENTAL OR CONSEQUENTIAL DAMAGES OF ANY TYPE OR NATURE. THE LIABILITY OF THE MANUFACTURER SHALL NOT EXCEED THE PRICE OF THE PRODUCT UPON WHICH SUCH LIABILITY IS BASED.

This warranty gives you specific legal rights, and you may have other rights which vary from state to state. Some states do not allow limitations on duration of implied warranties or exclusion of incidental or consequential damages, so the above limitations may not apply to you.