Zoeller Model J266 Sewage/Effluent or Dewatering Pump 0.5 HP 200V 3PH 15' Cord Nonautomatic

• Float operated, submersible (NEMA 6) 2-pole mechanical switch
• Durable cast construction, ASTM Class 25 cast iron, switch case and pump housing
• Cast iron base on models 267 and 268
• Engineered plastic base on model 266
• Non-Clogging Vortex Impeller Design. Engineered plastic impeller with metal inserts on models 266, 267 & 268 (1 PH).
• Model 267 available with cast iron impeller option. (Cast iron impeller standard on 3 Ph models)
• Not affected by materials normally found in drainage and sewage pumps
• Stainless steel screws, bolts, handle, guard and arm and seal assembly
• Neoprene square ring & gasket
• Oil filled, hermetically sealed motor
• Oil lubricated bearings
• Carbon and ceramic shaft seal
• Passes 2” (50mm) spherical solids
• 2” female and 3" NPT male discharge
• Model 268 contains combination 2” NPT female 3” NPT male discharge
• On point: 12” (30 cm) (automatic units)
• Off point: 4” (10 cm) (automatic units)
• Corrosion-resistant, powder coated epoxy finish
• Completely submersible
• Watertight and dust tight
• Automatic and non-automatic models available
• Models available packaged with a piggyback variable level float switch
• Automatic reset thermal overload protection (1 Phase only)

HERTZ: 60 HzHORSE POWER: 1/2 HPVOLTAGE: 200 VPHASE: 3 PhRPM: 1750 RPMTYPE: Split phase or 3 phaseINSULATION: Class BAMPS: 2.6OPERATION: Nonautomatic AUTO ON/OFF POINTS: 12" /4" DISCHARGE SIZE: 2" NPT SOLIDS HANDLING: 2" spherical solidsCORD LENGTH: 15'CORD TYPE: UL Listed, 3-wire neoprene cord and plugMAX HEAD: 21.5'MAX FLOW RATE: 128 GPMMAX OPERATING TEMP: 130° F (43° C)COOLING: Oil filledMOTOR PROTECTION: Auto reset thermal overloadMOTOR HOUSING: Cast iron PUMP HOUSING: Cast iron BASE: Engineered plastic UPPER BEARING: Sleeve bearingLOWER BEARING: Sleeve bearingMECHANICAL SEALS: Carbon and ceramicIMPELLER TYPE: Non-clogging vortexIMPELLER: Glass-filled plastic w/metal insert HARDWARE: Stainless steel MOTOR SHAFT: AISI 1215 cold rolled steel GASKET: Neoprene