Prev Next

Myers S40HT-11 High Temperature Effluent Pump 0.4 HP 115V 20' Cord Manual

Price: Discontinued
+ -
Discontinued or no longer available.
SKU: MYRS40HT11


Shipping Weight:
42.0 LBS
Shipping Dimensions
Length: 20 In
Width: 16 In
Height: 16 In
WARNING Cancer and Reproductive Harm - www.P65Warnings.ca.gov

myerslogopumps1.png

Discontinued

Myers S40HT Series High Temperature Effluent Pump Description

The Myers ® S40HT Series Submersible High Temperature Sump/Effluent Pumps are designed for effluent and wastewater removal, sump drainage, dewatering and flood control. They can be used in boiler blow down pits, condensate pits and as hot water pumps. Units have built-in thermal overload protection with automatic reset. the mechanical seal and ball bearings on the motor shaft are permanently lubricated. Stainless steel hardware and a heavy duty lift-out ring allow for easy disassembly after extended use.

Myers S40HT Series High Temperature Effluent Pump Typical Applications

  • Boiler Blow-Down Pits
  • Condensate Pits
  • Hot Water Sumps

Myers S40HT Series High Temperature Effluent Pump Features

  • All Cast Iron Housing, Volute Case and Impeller Resists the Most Extreme Corrosive Environments.
  • Rugged-Built, Oil-Filled Motor for Continuous Bearing Lubrication and Maximum Heat Dissipation.
  • Heat Sensor Overload Protection with Automatic Reset when Motor Cools to a Safe Operating Temperature.
  • Lower Ball Bearing Eliminates Sleeve Bearing Wear and Reduces Motor Wear.
  • Non-Clog Vortex Style, Ejector Vanes for Seal Protection.
  • Allows Easy Disassembly After Extended Service.
  • Prevents Oil Loss From - and Moisture Protection for - Motor.
  • Permanently Lubricated for Long Life.
  • Heavy-Duty Lift-Out Ring.
  • Float Switch NOT INCLUDED

Myers S40HT-11 High Temperature Effluent Pump Specifications

  • VOLTAGE: 1ø, 115V, 60 Hz
  • HORSEPOWER: 0.33 HP
  • AMP DRAW (full load): 12.0
  • MOTOR TYPE: Thermal Overload Protection
  • RPM: 1550
  • MAXIMUM HEAD: 21'
  • MAXIMUM CAPACITY: 45 GPM
  • SWITCH TYPE: Manual
  • MINIMUM SUMP DIAMETER: Simplex 24" Duplex 36"
  • DISCHARGE PIPE SIZE: 1-1/2" NPT
  • MAXIMUM SOLIDS HANDLING SIZE: 3/4"
  • IMPELLER TYPE: Cast Iron, Non-Clog Vortex
  • CORD LENGTH: 20' w/ Integrally Grounded Three-Prong Plug
  • CORD SIZE: 16/3; Type: SJOOW-A/SJOW
  • BODY CONSTRUCTION: Cast Iron
  • MAXIMUM LIQUID TEMPERATURE: 200°F (93°C)

Myers S40HT Series High Temperature Effluent Pump Performance Data


WARNING Cancer and Reproductive Harm - www.P65Warnings.ca.govWARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov

MYERS LIMITED WARRANTY

Myers® warrants to the original consumer purchaser (“Purchaser” or “You”) of the products listed below, that they will be free from defects in material and workmanship for the Warranty Period shown below

ProductWarranty Period whichever occurs first:
Jet pumps, small centrifugal pumps, submersible pumps and related
accessories
12 months from date of original installation, or 18 months from date of manufacture
Fibrewound Tanks5 years from date of original installation
Fibrewound Tanks5 years from date of original installation
Sump/Sewage/Effluent Products12 months from date of original installation, or 36 months from date of manufacture
Battery Backup Units
MBSP-2, MBSP-2C
MBSP-3, MBSP-3C
12 months from date of original installation, or 18 months from date of manufacture
24 months from date of original installation, or 30 months from date of manufacture
Wastewater Solids Handling Pumps12 months from date of shipment from factory or 18 months from date of manufacture

Our warranty applies only where such products are used in compliance with the requirements of the applicable product catalog and/or manuals. For additional information, please refer to the applicable standard limited warranty featured in the product manual.

Our warranty will not apply to any product that, in our sole judgement, has been subject to negligence, misapplication, improper installation, or improper maintenance. Without limiting the foregoing, operating a three phase motor with single phase power through a phase converter will void the warranty. Note also that three phase motors must be protected by three-leg, ambient compensated, extra-quick trip overload relays of the recommended size or the warranty is void.

Your only remedy, and MYERS’s only duty, is that MYERS repair or replace defective products (at MYERS’s choice). You must pay all labor and shipping charges associated with this warranty and must request warranty service through the installing dealer as soon as a problem is discovered. No request for service will be accepted if received after the Warranty Period has expired. This warranty is not transferable.

MYERS SHALL NOT BE LIABLE FOR ANY CONSEQUENTIAL, INCIDENTAL, OR CONTINGENT DAMAGES WHATSOEVER.

THE FOREGOING LIMITED WARRANTIES ARE EXCLUSIVE AND IN LIEU OF ALL OTHER EXPRESS AND IMPLIED WARRANTIES, INCLUDING BUT NOT LIMITED TO IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. THE FOREGOING LIMITED WARRANTIES SHALL NOT EXTEND BEYOND THE DURATION PROVIDED HEREIN.

Some states do not allow the exclusion or limitation of incidental or consequential damages or limitations on the duration of an implied warranty, so the above limitations or exclusions may not apply to You. This warranty gives You specific legal rights and You may also have other rights which vary from state to state.

This Limited Warranty is effective April 1, 2014 and replaces all undated warranties and warranties dated before April 1, 2014.

We've been helping customers since 1953

Trust Guard Security Scanned